Skip to content
English
Go Back to Home Page
  • There are no suggestions because the search field is empty.

Fix "Calibration Tool Not Found" Error

If you're encountering the "Calibration Tool Not Found" error on your Keyline machine, follow these machine-specific troubleshooting steps:

Ninja Laser

  1. Check Tracer Alignment: Ensure TL003 is in the tracer shaft and TL000 is on the jaw.

  2. Insert the Calibration Template: Place the silver rectangle with a key ring into the jaw.

  3. Confirm Jaw Placement: Ensure the jaw is properly aligned and fully secured.

  4. Remove the Tip Stop: This allows the tracer to move freely.

  5. Check Tracer Contact: Verify the tracer is aligned with the template—adjust if needed.

Gymkana

  1. Tracer Positioning: Ensure T08 is on the right and T00 is on the left.

  2. Check Tracer for Straightness: Ensure both tracers are perfectly aligned.

  3. Lower and Lock the Tracer Knob: Ensure the knob is securely in the down position.

  4. Insert the Calibration Template: Use the silver metal rectangle with a key ring and install it with the rear stoppers.

  5. Secure in U Jaw: Push the template firmly into the U Jaw and lock it in place.

Download Gymkana Calibration Guide (PDF)

Pro Source

  1. Tracer Positioning: Confirm T08 is on the right and T00 is on the left.

  2. Check Tracer for Straightness: Ensure both tracers are perfectly aligned.

  3. Lower and Lock the Tracer Knob: Ensure the knob is securely in the down position.

  4. Insert the Calibration Template: Use the silver metal rectangle with a key ring and install it with the rear stoppers.

  5. Secure in U Jaw: Push the template firmly into the U Jaw and lock it in place.

BD Laser

  1. Tracer Check: Ensure the tracer is straight and labeled TL003.

  2. Jaw Placement: Verify the correct jaw is fully left in the carriage and secured.

  3. Calibration Template: Confirm the silver rectangle with a key ring is properly placed on the jaw.

  4. Tracer Contact: Ensure the tracer touches the calibration template—adjust if necessary.

994 Laser

  1. Tracer Check: Ensure the tracer is straight and labeled TL003.

  2. Jaw Placement: Verify the correct jaw is fully left in the carriage and secured.

  3. Calibration Template: Confirm the silver rectangle with a key ring is properly placed on the jaw.

  4. Tracer Contact: Ensure the tracer touches the calibration template—adjust if necessary.

Still Need Help? Contact techsupport@keyline-usa.com for assistance.